Thursday, 6 December 2012
2004 Honda CBR 600 RR-F41/flush mount signal installation
Honda CBR 600RR-Besitzer, who want to install the flush mount signal, could help this publication for you. This PDF file is a page only shows how to perform the installation. Here is the tips of the publication:
1.) In regard to the factory signals remove switch and install us, you must remove the entire top panel.
2.) Remove the original train from the top panel signals. Cut the plug from the factory indicators can and it in the Blinker g.c.. splice. Simply place the g.c..-signals in the stain on the left panel is free through the factory signals. The wires go through the large hole in the cover and the screw will fit through the small hole.
3.) Screws using the 3 mm to the signal in the Terminal Panel. The screws installing the rear after the signal into the recess in the casing is fully inserted.
4.) The Red wire is positive and the black is negative. The led's do not work if they are wired backwards. The CBR wiring uses a 3 wire Setup, which uses a running light. You must use only the signal cables and the Earth wire. The running light cable is not used.
get 2004 Honda CBR 600 RR-F41/flush mount signal installation here
